About Us

(1).On the molding tool should reasonable arrangement position, size andquantity.
(2).Should design the air hole on the molding tool.Its function is:1.Theair leads a MoldHave.2.Should periodically be anti- to enter the air pressure, to keep the tiny bore of well ventilated steel unimpeded.
(3).Notice the grinding machine, miller...etc. hard slice to pare to process, may Stop the tiny bore,Should use the line to incise, the electricity pulse and laser etc. of soft process.On-line sliceMow to process should raise to process the speed slightly, too slow probably in tiny boreProduce to give or get an electric shock the arc , to the silk disadvantage of molybdenum .The reasonable usage throws the light, most idealProcess with a machine,can process 800-1000# sand paper orThe oil stone, should at any time check the well ventilated function, best is to assembled to complete a The side enters the spirit to throw the light simultaneously.Clean with the acetone after process, if use the superVoice The wave adds the acetone to clean, the result is better.
(4).Assemble shouldn't use the direct knock of hard thing, will stop up the tiny bore thus, should Knock to go into with the wood system or the rubber hammer.
(5).Draw to be to lie the quality in the surface with the acetone or kerosenes after assemble, make use of to give vent to anger The bore enters the spirit, checking the well ventilated result.If discover that the well ventilated function descend, can use to enhance the machine, pulse,The laser wait soft process the way to make up.

The characteristic of the well ventilated steel


(1).Lower to note the pressure of mold , reduce to model and protect to press time.
(2).Raise the molding tool for cent the type face of match the degree tightly,Raise a pole and inset the match of the pieceAbility, did not need make useof divide the type face or the other row annoy the system, avoiding discardthe side produce Living.
(3).Can make because of sprinkling to be partial to the thin product of, wall etc.Is difficult to model the problem to be resolveAlleviate the solution.
(4).Because modeling the material heat output air and the molding tool cavityinside gather together quickly output of burnt, flow the mark ,Lack to anticipate, inhale to result in of transform the etc., the blemish can get to solve well.
(5).The skin product of the plastics, because of the output glow-in-the-dark of the heat high pressure, the well ventilated steel can solve to alleviate thesolution.
(6).Lower and remove the internal help dint of model the piece, keep product from trans form and bend .
(7).Raise the production efficiency, economize the production cost.
(8).Can in the molding tools, such as plastics plastics and rubber...etc. And Take to press the row spirit situation otherly.
SIZE

 

1.Average tiny bore diameter:15-20 microns
2.Density:6.36g/cm3
3.The anti- pulls the strength:790-810 Ns/ m㎡
4.Slice to pare the function:Good
5.Defend the rust and defend sour:Good

 

Copyright © Changsha ENYU Engineering Equipments Co., Ltd. all rights reserved.
　　　　　Email: enyu@enyudrill.com www.enyudrill.com